Cooper Security 9751 Guide de l'utilisateur télécharger pdf (Page 23)

496661 23

As you trigger a detector the

keypad and internal sounder give a

short tone. The display shows the

zone number of any detector(s)

that you have triggered. If there is

more than one detector triggered

then the display show the number

of each detector in turn.

4. Press to stop the test when you have triggered all the detectors.

Note:

1. You can abandon the test at any time by pressing .

2. You cannot test Fire, PA or other types of 24 hour zone with this command.

3. You cannot test tamper circuits with this command.

Starting a Call Out to <Downloader>

Your Installer may be using a personal computer connected to the telephone

network in order to program your alarm system. The software the Installer

uses to program your alarm system is called <Downloader>.

There may be times when your Installer asks you to make your alarm system

start a telephone call out to the Installer's <Downloader> . Your alarm system

is programmed to call three different telephone numbers. You do not have to

know these numbers, your Installer will tell you to select one of them by

pressing keys 1, 2 or 3. To start the call:

1. Key in your access code.

2. Press 0.

The display shows:

3. Press 1, 2 or 3 (as instructed by your Installer) then .

Your system starts calling your Installer's

computer.

Your alarm system may be connected to <Downloader> for several

minutes.

When the <Downloader> has finished and the connection is broken the

keypad display shows the time and date.

4. Special Functions

"beep"

1 2 ... 18 19 20 21 22 23 24

Pas de commentaire

Cooper Security 9751 Guide de l'utilisateur Page 23