Cooper Security Homelink 75 Guide d'installation télécharger pdf (Page 10)

Administration

Page 10

Omit Zones

You may wish to prevent a zone causing an alarm. For

example, if you have a fire door that is normally closed

and protected by a detector you may wish to leave it

open for fresh air or to move goods in and out. To do this

the control unit allows you to "Omit" a zone.

The control unit allows you to omit a zone for one

setting/unsetting cycle. You will have to omit the zone

again for the next setting/unsetting cycle.

1. Enter the User Menu and select Omit Zones.

The display shows the first of a list of zones.

2. Press u or n to highlight the zone you wish to

omit.

3. Press CHANGE to mark the zone for omission.

The character at the end of the line changes to an

"O" to show that the zone will be omitted.

If you change your mind then press CHANGE until

the end of the line shows an "I".

4. Repeat steps 2 and 3 for any other zone you wish

to omit (or include).

5. Press DONE to store the changes you have made.

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 31 32

Pas de commentaire

Cooper Security Homelink 75 Guide d'installation Page 10