Cooper Security 9751 Manuel d'installation télécharger pdf (Page 89)

4. Programming

496964 Page 81

59: External Sounder Tamper

This Command specifies which one of two tamper arrangements is used to

connect the control unit to the external sounders.

Option

0 Tamper return uses negative voltage

1 Tamper return is terminated with a 2k2 resistance.

Select the appropriate option for the sounder fitted to the system.

60: Level B Final Exit Operation

In a single system, this Command specifies how the system treats Final Exit

zones during part set B. If you select option 0, any Final Exit zones included in

Level B continue to act as Final Exit zones during part set B. If you select

option 1, these zones act as Normal Alarm zones during part set B.

Note: This Command is not available in a partitioned system.

61: Level B Entry Route Operation

In a single system, this Command specifies how the system treats Entry

Route zones during part set B. If you select option 0, any Entry Route zones

included in Level B continue to act as Entry Routes during part set B. If you

select option 1, these zones act as Final Exit zones during part set B.

Note: This Command is not available in a partitioned system.

62: Level/Partition B Exit Mode

This Command sets the exit mode for Level or Partition B.

In a single system, the options are:

Option

0 The keypad sounders and any internal sounders give a low tone

during exit of Level B. Use Command 65 to select the exit time.

1 Instant Set (no exit tone)

2 Silent Set. Use Command 65 to program the Exit time. At the end of

the exit time the keypad gives a double "beep" confirmation tone.

3 Makes the Level B exit mode the same as Level A.

1 2 ... 84 85 86 87 88 89 90 91 92 93 94 ... 147 148

Pas de commentaire

Cooper Security 9751 Manuel d'installation Page 89