Cooper Security i-on 16 Guide de l'utilisateur télécharger pdf (Page 6)

i-on30EX

Page 2

Installer Programming

Interface

Once fitted and powered up, you can

program the control unit through any

compatible keypad connected to the bus

cable. The Installer Menu allows you to

specify all the operating parameters for an

individual installation.

If you wish, you can also connect a PC or

laptop to the USB port on the control unit

pcb and use Cooper Security‟s Downloader

software to program the control unit.

Note: Some programming options can

make the installation non-compliant with

EN50131. The relevant options are noted in

the “Installer Menu” section of the i-on

Range Engineering Guide.

About this Guide

This guide shows the simple procedure

required to physically install the control

unit, connect keypads, expanders and

power supplies and power up the system

for the first time.

When you have completed the physical

installation please consult the i-on Range

Engineering Guide for details of configuring

the system to meet your customer‟s

requirements. For your convenience page

25 of this installation guide contains a

condensed reference table of the Installer

menu.

2. Before You Begin

Preparation

Before installation you should carry out a

survey of the site. You need to know how

many and what kind of detectors will be

monitored by the control unit. You also

need to assess where any radio expanders

must be placed in order to receive radio

signals from their detectors successfully.

To do this you should conduct signal

strength tests. Cooper Security produce the

Scantronic 790r hand held signal strength

meter and 734r-01 test transmitter for this

purpose. Please read the 790r manual for

details.

Siting the Control Unit and Wired Zone

Expanders

Do site the unit:

Upright, battery at the bottom. (This

does not apply to the wired zone

expander.)

Within a protected zone.

Do NOT site the unit:

In the entry or exit zones, or outside

the area covered by the alarm system.

Next to electronic equipment,

particularly computers, photocopiers or

other radio equipment, CAT 5 data lines

or industrial mains equipment.

Siting Keypads

If fitting two or more keypads then make

sure that you place the keypads more than

one metre apart from each other. (At less

than one meter separation the proximity

tag readers in each keypad will interfere

with each other.) Remember not to place

keypads on opposite sides of the same wall.

Siting Wireless Zone Expanders

Do site the unit:

Upright.

Within a protected zone.

As high as possible. However, do make

sure that the unit is on a similar level to

the transmitters or receivers.

More than 10m from another radio

expander.

1 2 3 4 5 6 7 8 9 10 11 ... 35 36

Commentaires sur ces manuels

Pas de commentaire