Cooper Security M2000 Guide de l'utilisateur télécharger pdf (Page 21)

Troubleshooting

Setting the System with Zones Active

Overview

If you try to set the system with one or more

zones active, the control unit will:

EITHER stop setting and make the internal

sounders give a single low error tone to

draw your attention to the display.

OR cause the internal sounders to give a

high repeating pair of tones to tell you that it

cannot set and will start an alarm at the end

of the exit time.

Single Error Tone

Following Zones

Are In Error :-

1. The system gives a error tone and

suspends the exit procedure.

Office window

2002 Active

2. The display then scrolls through the

active zones.

Office door

2001 Active

3. Investigate why the zones are active

and rectify the cause. (See notes.)

*NO ERROR ZONES*

PRESS ENT TO SET

4. When all zones are ready, the display

shows the message opposite. Press [

to re-start the exit procedure. Continue

as normal.

)

To abandon the setting procedure without rectifying the active

zones, press ].

)

Your system may allow you to continue setting with some zones

active. You must ask your Installer which zones they are. If you can

leave those zones active, press [ to continue setting. (If setting by

telecommand, press the button once more.)

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 27 28

Pas de commentaire

Cooper Security M2000 Guide de l'utilisateur Page 21