Cooper Security i-on 16 Guide de l'utilisateur télécharger pdf (Page 11)

Everyday Operation

Page 9

If the System Will Not Set

Normally, the system will set only when all the detectors are

“quiet”, that is: not reporting any activity. (This does not apply to

those detectors on your exit door or exit/entry route. The system

expects these detectors to be active as you leave the protected

area.)

If you try to set when one or more detectors are still active then

the display shows the words “SETTING FAULTS” and which zones

are active.

You can make the system “omit” those active zones, either while

you are setting the system (see below) or beforehand (see page

16 for instructions on how to omit zones before setting the

system).

1. Follow the instructions on page

6 to set the whole system.

If any detectors are not yet

ready to be set then the

display shows, for example:

SETTING FAULTS

Z02 A Back Door

2. EITHER Press Y to carry on

setting.

The system sets with the

active zones omitted.

OR Stop the setting process by

pressing X.

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 31 32

Pas de commentaire

Cooper Security i-on 16 Guide de l'utilisateur Page 11