Cooper Security i-on 16 Guide de l'utilisateur télécharger pdf (Page 12)

Everyday Operation

Page 10

Setting With a Remote control

Note: You must program the control unit to recognise ("learn") a

remote control, see page 23.

Secure all your windows and doors.

Make sure the system is idle, and that you can hear the warning

tones from the keypad.

1. On the remote control, either press A (full set) or B (part

set), see page 20.

The keypad sounds the exit warning tone.

2. Leave by the exit door and make sure it is closed properly (if

you have not already done so).

At the end of the exit time the warning tone stops you should

hear a double “beep” confirmation tone. The display shows

the message "System Set" for a few seconds. The installer

may also have programmed your external sounder/strobe to

flash briefly.

While the system is set the display shows the standby screen

and the left hand LED glows.

If The System Will Not Set

If one of the detectors is still active when you try to set the

system then you will not hear the exit warning tone.

What happens next depends on how the installer has set up your

system.

a) Try pressing A once more on your remote control. If the

installer has programmed the system to do so then it will carry on

and set, omitting the active detector.

b) If the system will not set on the second press of button A then

you will have to go to the keypad and set the system from there.

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 31 32

Pas de commentaire

Cooper Security i-on 16 Guide de l'utilisateur Page 12