Cooper Security i-on160EX Manuel d'utilisateur télécharger pdf (Page 36)

3. Setting and Unsetting i-on40 & i-onEX Range

Page 30

Figure 6. Keypad Display Showing Active Zone

Investigate the zone listed on the display and see if you can

rectify the fault. If your system has been programmed to then

you can “omit” the affect zone beforehand (see page 40 for

instructions on how to omit zones before setting the system).

Note that there may be more than one zone with a fault.

Other Reasons Why the System May Not

Set

There are several other events that can show fault warnings on

the keypad and prevent your system from setting. Your Installer

may have programmed your system to allow you to override the

fault warnings and continue setting. Alternatively, you may need

to call the Installer to rectify the fault first. In addition, the faults

that you are allowed to override in a Security Grade 2 system

may require an Installer‟s assistance in a Security Grade 3

system.

The table below shows the keypad message for each fault, what

the message means, and who can override the fault in either a

Security Grade 2 or Grade 3 system.

Override by:

Message

Meaning

Grade 2

Grade 3



A Hold Up Alarm device

is still active. (If a user

has forgotten to reset

the device an installer is

not required.)

Installer



A part of the system has

been tampered with.

Installer

SETTING FAULTS

Z041 Back door

1 2 ... 31 32 33 34 35 36 37 38 39 40 41 ... 121 122

Pas de commentaire

Cooper Security i-on160EX Manuel d'utilisateur Page 36