Cooper Security i-on160EX Manuel d'utilisateur télécharger pdf (Page 76)

4. Administration i-on40 & i-onEX Range

Page 70

However, the sequence of

key presses is the same for

all i-on control units.

8. Press  or  to display the

output you wish to test.





a). Press .

The keypad gives a double

“beep” confirmation tone. The

keypad display shows:

The control unit turns on the

output. Check that that it is

working as expected.

Note: Outputs connected to radio

output modules may take

several seconds to change

state.





b) Press  again to turn the

output off.

The keypad gives a double

“beep” confirmation tone. The

keypad display shows:





9. Press  to end the test.





NOTE: Make sure no one tries to activate an output by means of

a remote control while you perform the test.

When you complete the test check that the output is back

in the state it had before testing. For example, if the output

was off before testing, make sure it is off after testing.

Remotes and Two-way Keyfobs

1. Make sure the display shows

the standby screen.





2. Press .





1 2 ... 71 72 73 74 75 76 77 78 79 80 81 ... 121 122

Commentaires sur ces manuels

Pas de commentaire

Cooper Security i-on160EX Manuel d'utilisateur Page 76

Commentaires sur ces manuels

Produits connexes et manuels pour Systèmes de contrôle d'accès de sécurité Cooper Security i-on160EX