Cooper Security 9651 Manuel d'installation télécharger pdf (Page 66)

Programming - Programming Commands 9651

Page 62 11772232

Option

00 Not Used 19 Smoke Detector

01 Fire 20 Not used

02 PA 21 Battery Fault

03 Burglar 22 System Alarm

04 Open/Close 27 Not used

05 Alarm Abort 28 Not used

06 Technical Alarm 29 Not used

07 Not used 30 Pulse Set OP 1

08 RF Low Battery 31 Pulse Set OP 2

09 Supervision Loss 32 Pulse Set OP 3

10 RF Jamming 33 Pulse Set OP 4

11 AC Fail 34 Pulse Unset OP 1

12 Tamper Alarm (day tamper) 35 Pulse Unset OP 2

13 Open 36 Pulse Unset OP 3

14 Close 37 Pulse Unset OP 4

15 Zone Omitted 38 Set Fail

16 Medical Assistance 39 General Fault (Note 2)

17 Key Box 40 All Fault (Note 3)

18 Anti-Mask 41 Duress

Notes:

1. General Fault is active for all faults except AC Fail, Anti-Mask, Battery

Fault, Line Fault, Zone AC Fail, Zone Battery Fault and Zone Low

Battery.

2. All Fault is active for all faults (including AC Fail, Anti-Mask, Aux DC,

Battery Load Test Fail, Battery Missing, Comms Fail, Keypad Ident Fail,

Line Fail, Low Battery, Plugby Fail, uCom Fail, Zone AC Fail, Zone

Battery Fault, Zone Fault, Zone Low Battery and Zone Pwr O/P).

3. The control unit delays reporting/logging either mains loss, or exiting

engineering with mains loss, by 15-18 min (chosen at random). If you

select a Scandinavian default in Command 0, the control unit waits at

least 60 minutes before reporting.

4. The plug-by outputs can be tested using Command 92 (page 71).

1 2 ... 61 62 63 64 65 66 67 68 69 70 71 ... 87 88

Pas de commentaire

Cooper Security 9651 Manuel d'installation Page 66