Cooper Security 9751 Guide de l'utilisateur télécharger pdf (Page 35)

2. Programming Commands

497096, issue 3 Page 29

60: Level B Final Exit Operation

In a single system, this command specifies how the system treats Final Exit

zones during part set B. If you select option 0 (the default), Final Exit zones

included in Level B continue to act as Final Exit zones during part set B. If you

select option 1, these zones act as Normal Alarm zones during part set B.

Note: This command is not available in a partitioned system.

61: Level B Entry Route Operation

In a single system, this command specifies how the system treats Entry Route

zones during part set B. If you select option 0 (the default), Entry Route zones

included in Level B continue to act as Entry Routes during part set B. If you

select option 1, these zones act as Final Exit zones during part set B.

Note: This command is not available in a partitioned system.

62: Level/Partition B Exit Mode

This command sets the exit mode for Level or Partition B. The keypads give a

double "beep" confirmation tone at the end of all setting modes, including

Silent Set. The default is option 0, Timed.

In a single system, the options are:

Option

0 Timed. The keypad sounders and any internal sounders give a low

tone during exit of Level B. Use Command 65 to select the exit time.

1 Instant Set (no exit tone). Use this option to make the system set

without delay or exit tone.

2 Silent Set. Use this option to make the system set without an exit

tone. Use Command 65 to program the exit time.

3 Makes the Level B exit mode the same as Level A.

1 2 ... 30 31 32 33 34 35 36 37 38 39 40 ... 95 96

Pas de commentaire

Cooper Security 9751 Guide de l'utilisateur Page 35