Cooper Security Homelink 75 Guide de l'utilisateur télécharger pdf (Page 76)

Programming Reference - Reporting 7510r

Page 72

telephone number before accepting a request to

process a SMS message.

Line Fail Reporting

This menu lets you program the system to respond with

either audible or silent alarms when the control unit

detects a fault on one of its communication lines. To

program Line Fail Reporting select

Reporting, Line Fail

Reporting.

If you have a GSM or ISDN module you can set up Line

Fail reporting for either the PSTN line attached directly to

the control unit, or for the attached module.

The exact response depends on whether the system is set

or unset, as follows:

Disabled.

The control unit does not monitor the telephone line.

Audible.

If the system is unset then the system logs the

event. The control unit produces a short audible tone

every minute. Entering a valid access code silences

the sounders and the display indicates a telephone

line fault. The system can be set again with the line

fault present.

If the system is set then the control unit logs the

event but does not give any tone or display. The

control unit cancels any programmed siren delay if

the line is out of order when an alarm occurs.

Note: Audible response is the NSI recommendation for

line fault.

Silent.

If the system is unset then the display indicates a

telephone line fault and the control unit logs the

event. The system may be set again with the line

fault present.

If the system is set then the control unit does not

give any indication or tone but does log the event.

The control unit cancels any programmed siren delay

if the line is out of order when an alarm occurs.

1 2 ... 71 72 73 74 75 76 77 78 79 80 81 82 83 84

Pas de commentaire

Cooper Security Homelink 75 Guide de l'utilisateur Page 76