Cooper Security i-on16 Guide d'installation télécharger pdf (Page 18)

2. Alarms i-on16

Page 18

Press  or  to see the name of

the zone (if the installer has

programmed one), for example:





Press  to restore the display to

normal.





If you wish to see any other zones that were triggered during the

alarm, look in the log (see page 52).

If You Cannot Reset the System

Your system may be programmed so that it has to be reset by an

installer after an alarm.

If the top line of the

display shows:

Then contact your alarm

installer.





The installer will either come to your site and reset the system

for you, or, if the system has a suitable communicator fitted,

send a signal to the control unit to allow you to reset the

system.

Remote Reset (aka Anti-Code Reset)

The installer may have programmed your system so that they can

give you a special code to reset the alarm system.

The screen will tell you where the

alarm occurred, for example:





It will also show a message asking

you to call the alarm company, for

example:





The number displayed on the bottom line is a special code

(“4321” is just an example). Note this code down, you will need it

when you talk to the alarm company.

Press  to clear the message and the display returns to normal.

Call your alarm company and tell them that an alarm has

occurred.

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 89 90

Commentaires sur ces manuels

Pas de commentaire

Cooper Security i-on16 Guide d'installation Page 18

Commentaires sur ces manuels

Produits connexes et manuels pour Systèmes de contrôle d'accès de sécurité Cooper Security i-on16