Cooper Security i-on16 Guide d'installation télécharger pdf (Page 30)

3. Setting and Unsetting i-on16

Page 30

LEDs “A” to “D” should be

dark, showing that the

system is unset.

Note: The installer may have

disabled the LEDs to ensure

that the alarm system

meets the appropriate

standards.

Using Radio Keypads and Remote

Controls.

Using a Radio Keypad

Setting

Secure all your windows and doors. Make sure the system is idle,

and that you can hear the warning tones from the sounders.

1. Key in a valid access code.

2. Press either A, B, C or D to set the portion of system that

you require.

(If you wish to stop setting while the exit tone sounds, then

press .)

The left hand LED glows to show that the keypad is

transmitting.

3. Complete setting using the method programmed by the

Installer (see “3. Finishing Setting” on page 24).

Unsetting

1. Enter by the designated entry door.

2. Key in a valid access code.

3. Press .

Silencing an Alarm

1. Key in a valid access code.

2. Press .

1 2 ... 25 26 27 28 29 30 31 32 33 34 35 ... 89 90

Pas de commentaire

Cooper Security i-on16 Guide d'installation Page 30