Cooper Security i-on16 Guide d'installation télécharger pdf (Page 31)

i-on16 3. Setting and Unsetting

Page 31

Using a Proximity Tag With a Radio Keypad

If you wish to use a Proximity Tag with the radio keypad in place

of an access code, then hold the tag up against the proximity tag

sensor (see Figure 6).

The keypad glows blue and gives a “click” to show that it has

recognised the tag.

Figure 6. Radio Keypad

Note: The radio keypad does not show the status of the alarm

system at all. The left hand “Transmit” LED glows only to

show that the keypad is sending a command to the control

unit.

Using a Remote Control

Setting

Note: You must ask your Master User to provide a suitably

programmed remote control, see page 74.

Secure all your windows and doors.

Make sure the system is idle, and that you can hear the warning

tones from the sounders.

1. Press the appropriate button on the remote control, either

full set (A) or part set (B) (see Figure 7).

“Transmit” LED

Proximity tag sensor

1 2 ... 26 27 28 29 30 31 32 33 34 35 36 ... 89 90

Pas de commentaire

Cooper Security i-on16 Guide d'installation Page 31