Cooper Security M2000 Guide de l'utilisateur télécharger pdf (Page 26)

Getting Started Engineering Manual

Logging out also logs out any other engineer currently logged in at a different keypad. If you

have been using more than one keypad, this prevents you from having to check each keypad

before you leave the site.

About the Engineer Menus

The options in the Engineer menus enable you to perform tasks such as setting up the system,

performing tests and viewing logged information. It is essential to configure the intruder panel

using the Engineer menu options before you hand over the system to the end user.

There are two top-level Engineer menus:

Engineer Menu 1, as described in Chapter 3. Engineer Menu 1 contains the options shown on

page 19.

Engineer Menu 2, as described in Chapter 4. Engineer Menu 2 contains the options shown on

page 97.

A full list of options and their positions within the menu hierarchy is given in the Quick

Reference on page 161.

Selecting Menu Options

To select an engineer option:

1. Press the | or ¬ button to scroll to Engineer Menu 1 or 2, then press [ to enter that

menu. Alternatively, press hotkey 1 (for Engineer Menu 1) or hotkey 2 (for Engineer

Menu 2), then [.

2. Once you are in an Engineer menu, use the scroll keys (| or ¬) or hotkeys to select the

required option. The option may itself be a menu containing further options.

In some cases, options are available only by scrolling.

Exiting from an Option or Menu

Pressing the ] key takes you one step back in the menu hierarchy or one step back in a

procedure (such as the procedure used by the Program Zones option described on page 20).

Note: IMPORTANT - When you return the system to user mode the control unit stores any

changes you have made. If you power down the system before returning to user mode then the

control unit will lose all the changes you made during that session.

1 2 ... 21 22 23 24 25 26 27 28 29 30 31 ... 179 180

Pas de commentaire

Cooper Security M2000 Guide de l'utilisateur Page 26