Cooper Security M2000 Guide de l'utilisateur télécharger pdf (Page 137)

Engineering Manual Engineer Menu 2-7

129

Option 2-7-3-3 – Confirming the Network Devices

Equipment 3

Confirm Devices

[

[ENT] to CONFIRM

002 LEC2S

[

No o f d e vic e s

Devic e type

Press to confirm and view next

device type. Press to exit

[

]

This option allows you to confirm the correct number of devices are connected to the network

ports.

It is not normally necessary to use this option, since the procedure is started automatically when

you enter your engineer code (if there have been changes to the devices attached).

)

A keypad may be shown as a "LEC2". If a key is pressed at the keypad, it will be included in

the remote keypad total the next time you use this option.

Option 2-7-3-4 – Checking a Zone's Resistance

1,01A Remote

02.200 K Ohms

[

1234567890123456

Equipment 4

Zone Resistance

Panel Zone 1

02.173 K Ohms

1. SELECT ZONE TO

VIEW

Press when you have finished

]

e.g.

Devic e typ e

Zone no. (network 1,

devic e 01, zone A)

Re s i s t a n c e

To se le c t zo n e :

Pr e ss o r



|¬

to sc roll, or

Press to c hoose zone on next network

(e.g. to change 0001 to 1001), or

Enter zone number (e.g. 0002)



You can use this option to view the resistance at a zone. For zones connected to the panel, the

accuracy of this measurement is better than 100 Ohms. An open circuit at a panel zone will

display as 11.463k Ohms.

The displayed resistance value for zones connected to an MSNode, MSPSU or keypad are

rounded and approximate.

Refer to page 98 for the expected resistance values for each condition at a zone.

1 2 ... 132 133 134 135 136 137 138 139 140 141 142 ... 179 180

Commentaires sur ces manuels

Pas de commentaire

Cooper Security M2000 Guide de l'utilisateur Page 137

Commentaires sur ces manuels

Produits connexes et manuels pour Systèmes de contrôle d'accès de sécurité Cooper Security M2000