Cooper Security 9751 Guide de l'utilisateur télécharger pdf (Page 18)

18 496661

User 02 default access code is " 002", User 03 is " 003" and so on up to

User 16 ( 016). However, the default access codes for these users cannot

set or unset the system, or use any of its special functions.

Note: 9751 systems can use four- or six- digit access codes, ask your Installer for

more information.

Duress Code

If your system is connected to an ARC, you may want to give some of the

users a Duress Code as well as their normal access code. Anyone with the

Duress Code can use any of the system facilities. However, if a user enters

the Duress Code to unset the system, then the control unit sends a silent

alarm call to the ARC. The Duress Code is designed for times when a user is

being forced to unset the alarm system by an intruder.

When the control unit is delivered from the factory the Duress Code is

" 017". This code is inactive until you change it.

Changing Access Codes

1. Enter User 01 access code.

The display shows:

2. Press 4.

The display shows:

3. Key in the access code you wish to change

and press .

The display shows

(for example):

At this point you can change the text that the

system displays on the keypad for each user code.

See "Changing User Names" below. If you do not

wish to change the text then press again.

4. Key in the new access code that you wish to use.

Note: Do not use 0 (zero) as the first digit of the code.

If you wish to delete a code, key in "0000".

5. Press to store the new code.

Changing User Names

When you key in the access code and press in step 3 above, the display

shows the current user name with a flashing cursor under the first letter.

Enter letters from the keypad one at a time by pressing a number key repeat-

4. Special Functions

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 24

Pas de commentaire

Cooper Security 9751 Guide de l'utilisateur Page 18