Cooper Security 9751 Guide de l'utilisateur télécharger pdf (Page 8)

8 496661

The keypad starts the

continuous exit tone.

4. Leave via the designated exit

route and close the final door.

The system sets seven

seconds after you close the

door and gives a double

"beep".

The keypad display shows

which Level is set.

Using an Exit Terminate Button to Set the System

An Exit Terminate Button is usually a button mounted outside the premises

by the final door. Pressing the button completes setting the system.

1. Close all doors and windows.

2. Key in your access code at the keypad.

3. Press the appropriate Level key.

The keypad starts the

continuous exit tone.

4. Leave via the designated exit route. Close the final door.

5. Press the exit terminate button.

The exit tone stops and the

system sets seven seconds

after you press the button.

The system gives a double

"beep" and the keypad

display shows which Level is

set.

Note: The Installer may have programmed your system to set after a fixed time even

if you do not press the exit terminate button. This is to make sure your

premises are protected even if you forget to press the exit terminate button.

Ask your Installer how your system is set up.

Part Setting

The Installer may have programmed your system so that you can protect part

of the premises while the rest is in use. Level keys B and C give different part

set areas. Level key A always sets the full system. Ask your Installer which

zones keys B and C cover.

2. Everyday Operation

Exit Tone

(see note)

"beep beep"

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 23 24

Pas de commentaire

Cooper Security 9751 Guide de l'utilisateur Page 8