Cooper Security 9751 Guide de l'utilisateur télécharger pdf (Page 5)

496661 5

Omit individual zones or act as an Escape key when entering com-

mands.

Enter programming and setting/unsetting commands.

The 725r Telecommand (Remote Setting Device)

If your alarm system has a 9955 radio expander connected to it then you will

be able to use a 725r telecommand (also called a remote setting device).

Figure 2. 725r Remote Setting Device

On the 725r the transmit LED glows when the device is sending a signal to

the alarm system. The buttons have the following functions:

(FULL) Sets the system to Level A.

(PART) Part sets the system to Level B.

(OFF) Unsets the system.

+ (FULL + OFF) Pressing both these buttons at the same time starts

a PA alarm.

About This Guide

The rest of this guide tells you how to use the system in more detail:

2. Everyday Operation Describes how to set and unset the system.

3. After an Alarm Tells you how to switch off the sounders after an

alarm, how to see what caused the alarm, and how

to reset the system so that it can be used again.

4. Special Functions Tells you how to use the more advanced features

of the system.

1. Introduction

Set Level A

Part Set (Level B)

Unset

Transmit LED

1 2 3 4 5 6 7 8 9 10 ... 23 24

Pas de commentaire

Cooper Security 9751 Guide de l'utilisateur Page 5