Cooper Security 9751 Guide de l'utilisateur télécharger pdf (Page 21)

496661 21

Tel Line Fault Communications (telephone line) fault detected.

Tel Line Rstr Communications restored.

Comms Fail The communicator failed to report.

AC Fail Mains failed.

AC Restore Mains restored.

Low Battery Standby battery is low.

Low Batt Rstr Standby battery restored.

Batt Missing 12V supply from standby battery not present.

Batt Missing Rstr 12V supply from standby battery restored.

Batt Load Fail Standby battery has failed load test. Call Installer.

Aux DC Fail Power supply to wired detectors has failed.

Aux DC Fail Rstr Power supply to wired detectors restored.

In the log user codes are represented by numbers as follows:

U00 Installer U19 Idle

U01 User code 1 U20 Telecommand

... ... U21 Keyswitch

U16 User code 16 U22 Remote Reset

U17 Duress code U23 Download

U18 Control Unit U24 Virtual keypad

Note that neither the Installer nor the user can erase the log.

Setting the Time and Date

The control unit contains an internal clock/calendar that runs as long as there

is power present (mains or stand-by battery). The system uses this clock to

mark the time and date on the system log. If the power supply fails for any

reason, and the stand-by battery is low, then the system loses track of the

correct time and date. You may also need to change the time if you live in a

country that uses summer/winter time. User 01 is the only access code that

can change the time and date.

To set the time and date:

1. Key in User 01 access code.

2. Press 6.

The display shows the date.

3. Key in two digits for the day followed by .

4. Key two digits for the month (01 for January, to

12 for December) followed by .

5. Key in two digits for the year, followed by .

The display shows the time.

4. Special Functions

1 2 ... 16 17 18 19 20 21 22 23 24

Pas de commentaire

Cooper Security 9751 Guide de l'utilisateur Page 21