Cooper Security i-on 16 Guide de l'utilisateur télécharger pdf (Page 14)

i-on16

Page 10

3. Installation

WARNING: Exposure to Radio Frequency Radiation

The radiated output power of this device is below those

levels considered safe by European exposure limits.

Nevertheless, when fitting the product place it in such a

manner as to minimise the potential for human contact

during normal operation. To minimise exposure, users

should be more than 200 mm from the device during

normal operation

Tools Required

790r signal strength meter and 734r test transmitter.

Flat screwdriver (small).

Philips screwdriver.

Drill.

5mm drill bit.

M5 36mm (four off) and 25mm screws (three off).

Wallplugs, filler.

Preparation

Before installation you should carry out a survey of the

site. You need to know how many and what kind of

detectors will be transmitting to the control unit. You also

need to assess where the control unit must be placed in

order to receive signals from the detectors successfully.

To do this you should conduct signal strength tests.

Cooper Security produce the Scantronic 790r hand held

signal strength meter for this purpose. Alternatively, you

can power the control unit from a battery and use its

built-in testing facility to measure the signal strength

from a detector that you temporarily place at each

planned location.

Siting the Unit

Do site the unit:

Upright (battery at the bottom).

Within a protected zone.

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 67 68

Pas de commentaire

Cooper Security i-on 16 Guide de l'utilisateur Page 14