Cooper Security i-on 16 Guide de l'utilisateur télécharger pdf (Page 38)

Programming i-on16

Page 34

Zone Attributes

The attributes available are:

Chime

When enabled by the user, the system gives a non-

alarm warning tone when any zones programmed as

‘Chime’ are opened. This facility operates only while

the system is unset.

Part Set

When a user presses button B (part set), the control

unit sets only those zones where the Part Set

attribute = “Yes”. (See also “Part Set Exit Mode” on

page 40 ).

Force Set Omit

The user can set the system while a zone with this

attribute is open (active). (You must enable this

feature in the System Options – Force Set menu See

page 44.)

Note: Some attributes are not available for certain zone

types. The display shows the available attributes.

External Siren

The external siren is a weather-proof battery powered

siren designed to operate on external walls. In an alarm

the control unit triggers the external siren at the same

time as the internal siren. The 760 external siren runs for

either: five seconds, three minutes, or 15 minutes

depending on the position of a link within the sounder.

To program the external siren select Detectors/Devices –

External Radio Siren .

Adding an External Siren

To make the control unit learn the ID of an external

siren:

1. Select Detectors/Devices – External Siren – Add/Del Ext

Siren.

The display shows two possible “memory slots” for

external sirens. A slot already allocated to a siren

shows a “*” at the beginning of its line.

2. Select an empty memory slot.

1 2 ... 33 34 35 36 37 38 39 40 41 42 43 ... 67 68

Pas de commentaire

Cooper Security i-on 16 Guide de l'utilisateur Page 38