Cooper Security i-on 16 Guide de l'utilisateur télécharger pdf (Page 33)

i-on16 Programming

Page 29

The control unit loads the factory default access

codes:

User 1: 1234, Installer: 7890.

After a short pause the keypad display shows the

time and date. The red LEDs glow to show an alert

that the panel lid is open.

The system may start a tamper alarm.

6. Remove the short from the Reset pins.

7. Reconnect the battery.

8. Close the end station lid (to restore the tamper

switch).

9. Key in 1234 to silence the sirens (if necessary).

Press Y twice (if necessary) to acknowledge any

alerts.

If the red LEDs around the navigation key still glow then

there may be an alert for a missing battery that needs

acknowledgement. To force the end station to check the

battery:

10. Enter installer menu and then leave it again.

11. Press Y, key in 1234, press Y again.

The navigation key LEDs should now glow green.

Restoring All Factory Default Programming

If you wish to restore all factory default options then:

1. From the Installer Menu select System Options, Restore

Defaults, Factory Defaults.

The display asks for confirmation.

2. Press Y to load defaults.

(Press X to go back to the Installer Menu without

changing defaults.)

The system loads all defaults except for Access Codes

and the Log (see Note).

The display returns to the Installer Menu.

Note: The log is protected and cannot be erased by the

Installer.

1 2 ... 28 29 30 31 32 33 34 35 36 37 38 ... 67 68

Pas de commentaire

Cooper Security i-on 16 Guide de l'utilisateur Page 33