Cooper Security i-on 16 Guide de l'utilisateur télécharger pdf (Page 55)

i-on16 Programming

Page 51

Enabled

The system rearms Channel 3 once the siren timer

has expired. Once the Channel is rearmed, the

system is ready to report any new alarm. The system

bypasses any detectors that are still violated.

Notes:

If a Final Exit Zone is triggered, Channel 3 becomes

active at the end of the Programmed Entry time.

Send Tamper as Burg

When using CID reporting this option allows you to

program the control unit to send tampers as alarm.

If you select Disabled, (the default) then the control unit

sends all CID messages as specified in Reporting – Alarms

– CID Events.

If you select Enabled then for full alarm response the

control unit sends tampers as burglary (BA) and sends

Contact ID 130 in place of Contact ID 137.

Dynamic Test Call

In dynamic testing the system makes a test call 24 hours

after the last alarm communication. To enable dynamic

testing select Reporting – Alarms – Dynamic Test Call –

Enabled.

Static Test Call

In static testing the system makes a test call either on:

Every day at one particular time of day or

On the same day of every week, or

On one day every month.

To make test calls at a set time every day select

Reporting – Alarms – Static Test Call – Daily. From the

display select a number between 01 and 24 to choose the

time of day for the call. For example, select 18 to

program the control unit to make a static test call at

6:00pm every day.

To make test calls on the same day every week select

Reporting – Alarms – Static Test Call – Weekly. From the

display select the day of the week on which the call

1 2 ... 50 51 52 53 54 55 56 57 58 59 60 ... 67 68

Pas de commentaire

Cooper Security i-on 16 Guide de l'utilisateur Page 55