Cooper Security i-on 16 Guide de l'utilisateur télécharger pdf (Page 60)

Programming i-on16

Page 56

Select a message from the list on the display. The control

unit will show you a list of telephone numbers. If you

gave a telephone number a name then the display shows

the name instead of the digits of the number.

Highlight a telephone number and press > until a “Yes”

appears after the number. Press Y when you have

finished. The control unit will send the selected speech

message to every telephone number with a “Yes” next to

it.

Note: There are a total of five voice messages available.

The control unit always sends the Home Message at

the beginning of every speech report. The control

unit then sends messages 1, 2, 3 or 4 to the

telephone numbers you selected.

Call Acknowledge

If the called party answers a speech dialler call, then they

can end the call by sending back a DTMF ‘5’.

With Call Acknowledge enabled the control unit ends the

call when it receives a DTMF ‘5’ or ‘9’. If the control unit

does not receive a DTMF ‘5’ or ‘9’ then it attempts to call

again (up to three times).

With Call Acknowledge disabled the control unit stops

further call attempts to that number as soon as it detects

a call being answered.

Note that after receiving a DTMF ‘5’ the control unit will

go on to call any other programmed speech dialler

numbers.

After receiving a DTMF ‘9’ the control unit will cancel all

further calls for the current alarm.

Line Fail Reporting

This menu lets you program the system to respond with

either audible or silent alarms when the control unit

detects a fault on one of its communication lines. To

program Line Fail Reporting select Reporting – Line Fail

Reporting.

The exact response depends on whether the system is set

or unset, as follows:

1 2 ... 55 56 57 58 59 60 61 62 63 64 65 66 67 68

Pas de commentaire

Cooper Security i-on 16 Guide de l'utilisateur Page 60