Cooper Security i-on 16 Guide de l'utilisateur télécharger pdf (Page 62)

i-on16

Page 58

5. Testing

If you think that part of the system is not working

correctly then you can use the Test option to test various

peripherals.

The Test option also lets you check the identity of Remote

controls, Panic Alarms and Tags.

To start testing, make sure the system is idle then:

1. Enter the Installer Menu and select Test.

The display shows the Test menu.

2. Select the part of the system that you wish to test.

You can test each part listed in the Test menu as follows:

Siren

Press > to turn the siren on and off again. The display

shows the word "On" when the siren operates. (This test

also operates any output programmed as “siren”.)

Keypad

Press each key once. The display shows a character in

response. Press both panic alarm keys together to test.

Press X to end the test.

Walk test

The display shows a list of all the detectors installed on

the system. Walk round and trigger each detector. Every

time you trigger a detector the control unit gives a double

tone. The display shows an “A” if you trigger the Alarm

input and a “T” if you trigger the Tamper.

The top of the display shows the number of zones left to

test. The control unit decreases the number of zones

every time you trigger an individual Alarm input.

Press Y to end the test.

Detector Signals

The display shows the strength of the most recently

received signal from each learned radio transmitter.

Ext Siren Signals

The display shows a list of the received signal strengths

from each 760r siren.

1 2 ... 57 58 59 60 61 62 63 64 65 66 67 68

Pas de commentaire

Cooper Security i-on 16 Guide de l'utilisateur Page 62