Cooper Security Homelink 75 Guide de l'utilisateur télécharger pdf (Page 40)

Programming Reference - Partitions 7510r

Page 36

Final Door Set.

Use this option to complete setting the partition by

closing a door fitted with a Final Exit zone detector.

Note that the exit time is infinite in this option.

Note: Do not try to make a PIR zone act as a Final Exit

for a partition. Radio PIR detectors have a “lock out”

period after each activation in order to conserve

battery power. When you set (or part set) a partition

a PIR may still be in lockout, during which it cannot

send a signal to complete the setting process.

Instant Set.

The partition sets immediately and without any tones.

Silent Set.

The partition sets after the exit time programmed in

the Entry/Exit Time menu but does not give any exit

tones. When the partition sets the control unit gives a

double beep.

As Partition 1

This option is available for partitions 2, 3 and 4.

When you select this option the system uses the

same setting mode as partition 1.

The control unit gives a double beep confirmation tone at

the end of all setting modes.

If you select Final Door Set exit mode then the system

allows a seven second settling time after closing a final

door.

Exit Time/Entry Time

You can give each partition separate entry and exit times.

The times can each take one of the following values

(seconds):

10, 20, 30, 45, 60, 120.

Alarm Response

You can give each partition an individual alarm response.

The responses available are:

Siren

Local alarm (siren only).

1 2 ... 35 36 37 38 39 40 41 42 43 44 45 ... 83 84

Pas de commentaire

Cooper Security Homelink 75 Guide de l'utilisateur Page 40