Cooper Security Homelink 75 Guide de l'utilisateur télécharger pdf (Page 79)

7510r Programming Reference - Testing

Page 75

Press BACK to end the test.

Detector Signals

The display shows the current and lowest value of the

received signal strengths from each learned radio

transmitter.

Ext Siren Signals

The display shows a list of the received signal strengths

from each 750r siren.

WAMs Signals

The display shows a list of the received signal strengths

from each 770r module.

Arm Station Signals

The display shows a list of the received signal strengths

from each 7525r arming station.

Outputs

The display shows a list of the outputs installed on the

system. Select the output you wish to test. Press DONE

to finish the test.

When you complete the test check that the output is still

in the state you wish it to be in.

NOTE: Make sure no one tries to activate the radio output

module using a telecommand or pendant when you

perform the test.

Telecommands

Press any button on the telecommand. The display shows

the identity and user of the telecommand, and the button

that the control unit believes you pressed. Press all the

buttons on the telecommand in turn.

Pendants

Press the button on the pendant. The display shows the

identity and user assigned to the pendant.

Panic Alarms

Press both buttons on the panic alarm transmitter. The

display shows the identity of the user assigned to the

panic alarm.

1 2 ... 74 75 76 77 78 79 80 81 82 83 84

Pas de commentaire

Cooper Security Homelink 75 Guide de l'utilisateur Page 79