4. Programming
Page 100 496964
To enter a telephone number:
1. Enter programming mode (if you are not already there).
2. Key in 115 (or 116) Y at the keypad.
The display shows (for example):
115:Tel No 1_
3. Press Y.
4. Key in the digits of the number. If necessary, press D to move the cursor
to the left to edit or delete the number. Press C to move the cursor to the
right.
The display shows (for example):
115: 1234_
5. Press Y.
The keypad gives a double "beep" and the system stores the number.
117: Account Number
With SIA formats, the control unit can report alarms using a six-digit account
code. Use leading zeros to pad the account code to the correct length if
necessary; for example; account 1234 would be 001234.
In a partitioned system, you can enter up to four account codes:
1. Enter programming mode (if you are not already there).
2. Key in 117 Y at the keypad.
The display shows:
117: Account No
3. Press Y.
The display shows (for example):
117: 123456 PA
4. If the account code is correct, press Y. To change the account code for
partition A, key in the digits of the new code. Press C between each digit
to move the cursor to the right. Press D to move the cursor to the left to
correct any mistakes. Press Y when the account code is correct.
The control unit stores the account code that
you entered and displays the account code
for the next partition (for example):
117: 123456 PB
5. Repeat step 4 for the account codes for partitions B, C and D.
Note: Some European countries use letters in account codes. The control unit
can accept B, C, D, E and F in account codes. To enter a letter at step 4,
press 2 or 3 repeatedly until the letter you require appears on the display
(see "Zone Programming – Zone Names").
Commentaires sur ces manuels