Cooper Security 9751 Manuel d'installation télécharger pdf (Page 15)

1. Introduction

496964 Page 7

If the Dual Key Alarm function is enabled (Command 87), users can trigger an

alarm by pressing the following pairs of keys simultaneously:

1 + 3 Panic Alarm

4 + 6 Medical assistance

7 + 9 Fire alarm

ScanProx Proximity Tag Reader

The ScanProx 934EUR-50 proximity reader module enables you to convert

9930 keypads into proximity tag readers. The module fits onto connector pins

on the keypad PCB, near the display module (Figure 11).

Once the ScanProx module is fitted, users can operate the alarm system by

presenting a tag to the front of the keypad instead of keying in an access

code.

Note: The control unit must be at V2.01.54 or greater for the ScanProx module

to work.

Expanders

You can attach hardwired or radio expanders to the control unit: two to the

9751, three to the 9752 and four to the 9851. You can use a combination of

the two types.

Hardwired Expanders

The 9954 hardwired expander enables you to connect wired detectors to the

control unit. Wired detectors can be connected in three ways:

1. Four-wire Closed Circuit Loop (CCL).

2. Two-wire Fully Supervised Loop (FSL).

3. Two-wire End of Line (EOL) resistor loop.

The table below shows the configurations possible. In all cases, a

combination of wired and radio expanders can be used if preferred.

Control

Unit

Wiring Type Standard

Zones

Expansion Zones

9751 FSL 8 wired 16 wired or 16 radio

CCL + common tamper 8 wired 16 wired or 16 radio

9752 FSL 8 wired 24 wired or 24 radio

CCL + common tamper 8 wired 24 wired or 24 radio

9852 FSL 8 wired 32 wired or 32 radio

FSL 16 wired 24 wired or 24 radio

CCL + individual tamper 8 wired 32 wired or 32 radio

EOL 8 wired 32 wired or 32 radio

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 147 148

Pas de commentaire

Cooper Security 9751 Manuel d'installation Page 15