Cooper Security 9751 Manuel d'installation télécharger pdf (Page 133)

4. Programming

496964 Page 125

Partition D remains set during the day. Partitions A, B and C are unset, so the

control unit leaves the common area unset. When users A, B and C leave at

the end of the day the control unit sees that all partitions are set and sets the

common area.

When the cleaners arrive in the evening, they open zone 1 and the control

unit starts the entry timer. The cleaners unset Partition D and the control unit

unsets the common area but leaves Partitions A, B and C set. When the

cleaners have finished, they set Partition D again and the control unit sets the

common area. In the morning, the first user to arrive unsets their partition, and

the control unit unsets the common area, leaving the other partitions

(including D) set.

If you do not use a common area and simply assign the lobby to Partition D,

you still have the problem of ensuring that the last user to leave sets Partition

D. If they forget, the lobby is unprotected in the time between the users

leaving and the cleaners arriving.

Note: You cannot use plug-on or plug-by communications in this scenario.

Partition D is set while Partitions A, B and C are unset. Partitions A, B

and C are set while Partition D is unset. Therefore, the plug-on or plug-

by communicator would indicate a closed system all the time.

1 2 ... 128 129 130 131 132 133 134 135 136 137 138 ... 147 148

Pas de commentaire

Cooper Security 9751 Manuel d'installation Page 133