Cooper Security 9751 Manuel d'installation télécharger pdf (Page 137)

496964 Page 129

5. TESTING

90: Reading the Event Log

The control unit keeps a log of recent events. The log can contain up to 250

events. Each event is described by a short text message. To review the event

log, make sure the system is in programming mode and then:

1. Key in 90Y.

The display shows the most recent event in the log.

2. Key in 1 to show earlier events or 3 to show later events.

3. Key in 4 to show the first event or 6 to show the last event.

4. Press Y to toggle between the event message and the event time.

5. Press X to leave the log.

The table on the following pages shows the messages that can be recorded in

the event log. Column 1 lists messages shown on the keypad displays and

column 2 lists corresponding messages in the printed log (9851 only). Each

event in the printed log is preceded by the date and time in numerical format.

Note: Neither the Installer nor the user can erase the log.

In the log, user codes are represented by numbers:

U00 Installer U19 Idle

U01 User code 1 U20 PA

... ... U21 Keyswitch

U16 User code 16 U22 Remote reset

U17 Duress Code U23 Download

U18 Control unit U24 Virtual keypad

Printing the Event Log (9851 only)

To print the event log, make sure the system is in programming mode, then

Key in 90 Y 0. To stop printing, press X.

To toggle the logging printer on and off, key in 90 Y 7. The keypad gives a

Chime tone when the printer is turned on and a "beep beep" confirmation tone

when the printer is turned off. This is a test mode and is cancelled if power is

lost. Use Command 180 to turn printing on indefinitely.

Figure 42 shows a sample of a printed log.

– 9851 -

14/12/01 18:42:30 Sounder Tamper

Figure 42. Sample Log Print

1 2 ... 132 133 134 135 136 137 138 139 140 141 142 ... 147 148

Pas de commentaire

Cooper Security 9751 Manuel d'installation Page 137