Cooper Security 9751 Manuel d'installation télécharger pdf (Page 70)

4. Programming

Page 62 496964

Enter letters from the keypad one at a time by repeatedly pressing a number

key until the display shows the letter you want. Figure 36 shows which letters

are assigned to each key. If you make a mistake, press C or D to move the

cursor to the letter you want to change and key in the new letter. To delete a

name completely, press D to move the cursor onto the first character of the

name and then press D again to clear the old name.

When you have finished entering the name, press Y.

ABCÆÅÄ DEF

GHI

JKL MNOØÖ

PQRS

TUV WXYZ

Space'():.-!&

Figure 36. Letters Generated by Each Number Key

Zone Types

The following table shows the values available for zone type.

Value Type Description

00 Not Used

(NU)

Identifies zones that are not used. The system ignores

zones of this type. It is not necessary to link the circuit

or anti-tamper connections.

01 Panic Alarm

(PA)

Operating a device programmed as "Panic Alarm" will

start either a silent alarm transmission to the ARC or

an audible alarm, depending on how you have

programmed PA Response (see Command 30). PAs

operate, whether the system is set or unset. PA zones

can be allocated to one or more partitions in a

partitioned system (A–D attributes on page 67) but

these attributes are not available in a single system.

1 2 ... 65 66 67 68 69 70 71 72 73 74 75 ... 147 148

Pas de commentaire

Cooper Security 9751 Manuel d'installation Page 70