Cooper Security 9751 Guide de l'utilisateur télécharger pdf (Page 72)

2. Programming Commands

Page 66 497096, issue 3

200: Forbikobler Entry Timer

This command sets the interval between a user entering the premises through

a Forbikobler entrance and an alarm going off, using one of the independent

entry timers configured with Commands 201 to 204. Any of the entry timers

can be assigned to any Forbikobler entrance. Entering the entry code into the

Forbikobler unit starts the selected entry timer.

Option

1 Entry Timer 1 (default)

2 Entry Timer 2

3 Entry Timer 3

4 Entry Timer 4

201 to 204: Entry Timers 1 to 4

Entry timers set the interval between a user entering the premises and an

alarm going off. There are four independent entry timers so that you can set

different intervals for different entrances, reflecting the time required to

complete each entry route.

Note: These replace the level-specific timers available on earlier control units (formerly

set with Commands 43, 64, 74 and 78). They provide a more flexible approach to

timed entry routes, enabling any timer to be selected for any entrance.

Each entry timer can be assigned to any zone of types FE (Final Exit), ER

(Entry Route) and FB (Forbikobler), using the zone programming commands

01 to X40 (see page 7). Set zone attribute X7 to a value between one and

four to select the required entry timer. Opening the zone starts the selected

entry timer.

Note: Compliance with PD 6662 / prEN 50131-1: 2004 (see page 85) requires that the

Entry Timer does not exceed 45 seconds.

Option

1 10 seconds

2 20 seconds (default)

3 30 seconds

4 45 seconds

5 60 seconds

6 120 seconds

Note: By default, Entry Timer 1 is assigned to all relevant zones.

1 2 ... 67 68 69 70 71 72 73 74 75 76 77 ... 95 96

Pas de commentaire

Cooper Security 9751 Guide de l'utilisateur Page 72