Cooper Security i-on40 Guide d'installation télécharger pdf (Page 10)

Entering and Leaving Installer Menu i-on40

Page 6

6. Remove the short from the Reset pins.

7. Reconnect the battery.

8. Close the control unit lid (to restore the tamper

switch).

9. Key in the Master User code 1234 to silence the

sirens.

Press Y twice (if necessary) to acknowledge any

alerts. To force the control unit to check the battery:

10. Enter installer menu and then leave it again.

The navigation key LEDs should now glow green.

Restoring Factory Defaults Only

If you wish to restore all factory default options, then:

1. From the Installer Menu select System Options –

Restore Defaults – Factory Defaults.

The display asks for confirmation.

2. Press Y to load defaults.

(Press X to go back to the Installer Menu without

changing defaults.)

The display asks you to select Partition Mode or Part

Set Mode.

3. Press A or B to select the desired mode.

The display asks you to select the zone wiring type.

4. Press u or n to display the desired wiring type on

the bottom line of the display and then press Y to

select it.

The system loads all defaults except for Access Codes

and the Log (see Note).

The display shows “

Factory defaults restored”.

5. Leave the Installer Menu to save the change (press X

until the display shows “

Leave Installer Menu ?” then

press Y.

Note: The log is protected and cannot be erased by the

Installer or any user.

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 115 116

Pas de commentaire

Cooper Security i-on40 Guide d'installation Page 10