Cooper Security i-on40 Guide d'installation télécharger pdf (Page 29)

i-on40 Installer Mode Programming

Page 25

1. Select Detectors/Devices – External Siren – Add/Del Ext

Siren.

The display shows four possible “memory slots” for

external sirens. A slot already allocated to a siren

shows a “*” at the beginning of its line.

2. Select the siren you want to delete.

The display shows the message “Delete Ext Siren”.

3. Press Y to make the control unit “forget” the siren ID

learned into that memory slot.

The control unit deletes the siren’s identity, removes

the “*” from the beginning of the line, and gives a

double beep.

Info Modules

The 771r Info Module is an external display module that

can show the setting state of the system or one or more

partitions. You must teach the identity of the i-on40

control unit to each Info Module that you wish to use.

If you wish to allocate an Info Module to individual

partitions then you must fit the appropriate jumpers

within the Info Module (see the 771r Installation Guide

supplied with the Info Module).

Adding an Info Module

To add an Info Module:

1. Select Detectors/Devices – Info Module .

2. Make sure the Info Module is in Learn Mode (consult

the 771r Installation Guide).

3. Select Teach Info Module.

The display shows the message “Is the receiver is in

learn mode?”.

4. Press Y on the i-on40 keypad.

The Info Module should beep twice to confirm that it

has learned the identity of the control unit.

The keypad display shows “Did the receiver beep

twice?”.

1 2 ... 24 25 26 27 28 29 30 31 32 33 34 ... 115 116

Pas de commentaire

Cooper Security i-on40 Guide d'installation Page 29