Cooper Security i-on40 Guide d'installation télécharger pdf (Page 34)

Installer Mode Programming i-on40

Page 30

1. Select Outputs – Radio Outputs – Add Outputs.

The bottom line of the display shows the first in the

list of eight available radio outputs.

2. Press u or n to select the radio output that you wish

to make the receiver learn and press Y.

The keypad displays a reminder: “Is the receiver in

learn mode?”

3. Make sure the receiver is powered up.

Follow the programming instructions for the receiver

to make it learn the control unit into the desired

channel.

4. At the control unit keypad, press Y.

The control unit starts broadcasting its own identity

to the receiver.

The control unit keypad displays the message: “Did

the receiver beep twice?”.

The receiver should beep twice to indicate that it has

learned the identity of the control unit.

4. Press Y to stop the control unit broadcasting its

identity.

Editing Radio Outputs

Once a receiver has learned an output from the control

unit you must set up the output behaviour at the control

unit by giving the output a type. You can also give each

output a text name.

To give a radio output a name:

1. Select Outputs – Radio Outputs – Edit Outputs.

The bottom line of the display shows the first in the

list of eight available radio outputs.

2. Press u or n to select the radio output that you wish

to name and press >.

(Hint: You can key in the output number you wish to edit,

for example:“05” to see output 05.)

The bottom line of the display shows the word

“Name”.

1 2 ... 29 30 31 32 33 34 35 36 37 38 39 ... 115 116

Pas de commentaire

Cooper Security i-on40 Guide d'installation Page 34