Cooper Security i-on40 Guide d'installation télécharger pdf (Page 52)

Installer Mode Programming i-on40

Page 48

Routes during part set.

In a Partitioned system, all Entry Route

zones, belonging to the partition, with

the Part Set attribute will continue to act

as Entry Routes during part set.

Final Exit In a Part Setting System, any Entry

Route zones with the Part Set B, C or D

attributes will act as Final Exit zones

during part set.

In a Partitioned system, any Entry Route

zones, belonging to the partition, with

the part set attribute will act as Final

Exit zones during part set.

Full Set Link

The Full Set Link option is available on Partitioned

systems. Full Set Link allows you to set up a Common

Area. See Appendix III for an example of how to use a

Common Area.

Partition 1 is always the Common Area. You can link

Partition 1 to any of the other partitions. When all of the

linked partitions are set, then the control unit Full Sets

Partition 1. In addition, the system takes on whatever

Alarm Response you have allocated to Partition 1.

System Options

This section of the Installer Menu contains a series of

options that affect the working of the alarm system as a

whole.

Note: The default settings for these options are compliant

with EN50131, see Appendix 1. Changes to some of

the defaults may render the system non-compliant.

Wired Zone Type

Normally the control unit asks you to select the zone

wiring type when you power up a new installation for the

first time, or when you restore the control unit to factory

defaults (see page 53).

1 2 ... 47 48 49 50 51 52 53 54 55 56 57 ... 115 116

Pas de commentaire

Cooper Security i-on40 Guide d'installation Page 52