Cooper Security i-on40 Guide d'installation télécharger pdf (Page 13)

i-on40 Installer Mode Programming

Page 9

1. Use the u or n keys to highlight a free zone and

press > or Y.

The display shows an “*” next to zones where the

control unit has already learned detectors.

2. Activate the detector’s tamper.

The keypad sounds a double “beep” when the control

unit successfully learns the detector. The display

shows a message to confirm that you have learned

the detector to the selected zone, together with the

current signal strength of the transmitter.

3. Either:

Press

X to go back to the list of zones so that you can

go on and learn other detectors.

OR:

Press > or Y to carry on giving a name, type and

attribute to the detector you have just learned (see

page 11 ).

Delete All

If you wish to remove all the radio detectors from a

control unit then select Detectors/Devices - Detectors –

Add/Delete Detectors – Delete All. Note that you cannot undo

this option. The control unit sets all radio zones to Not

Used, and erases the identities of all the radio

transmitters that it has learned. (Hint: when you see

Zone 17 on the bottom line of the display press u.)

Deleting a Single Detector

To delete an individual detector select Detectors/Devices -

Detectors – Add/Delete Detectors from the Installer Menu.

The bottom line of the display shows the first of the radio

detector zones: Zone 17.

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 115 116

Pas de commentaire

Cooper Security i-on40 Guide d'installation Page 13