Cooper Security i-on40 Guide d'installation télécharger pdf (Page 17)

i-on40 Installer Mode Programming

Page 13

full alarm. If a technical alarm zone is activated (and

the control unit correctly programmed, see page 60 )

then the control unit starts communication and logs

the event.

If the technical alarm occurs while the system is set,

then system makes no audible alarm. When a user

unsets the system the keypad shows an alert.

If a technical alarm zone is activated while the

system is unset then the system starts an alert

immediately and gives a brief tone from the keypad

every few seconds. When a user enters a valid access

code the keypad stops the tone and displays the zone

causing the alarm.

When the user acknowledges the alert by pressing Y

the control unit resets the technical alarm ready for

the next event.

Key Switch Momentary (08).

Use this zone type to connect a momentary keyswitch

to a single zone.

In a Part Setting system the keyswitch can Full Set or

unset.

In a Partitioned system you can allocate the

keyswitch to one or more partitions.

Each time a user operates the keyswitch the control

unit changes the current set state.

Key Switch Latched (09).

Use this zone type to connect a fixed position

keyswitch to a single zone.

In a Part Setting system the keyswitch can Full Set or

unset. As with Momentary keyswitches, you can

allocate the zone to one or more Partitions (see

above).

When the user closes the keyswitch contacts the

control unit sets the allocated Partition. When the

user opens the contacts the control unit unsets the

allocated Partition.

Notes:

1. The keyswitch zone types are intended for use on

zones that connect to an access control keypad,

electronic key or other type of hardwired device used

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 115 116

Pas de commentaire

Cooper Security i-on40 Guide d'installation Page 17