Cooper Security i-on40 Guide d'installation télécharger pdf (Page 63)

i-on40 Installer Mode Programming

Page 59

code. This acts as a seed for computing both the reset

code and its anti-code. The ARC usually generates the

CSID code.

To install the CSID code:

1. Call the ARC and obtain the CSID code.

2. Enter the Installer Menu and select System Options –

Remote Reset.

3. Key in the CSID code. As you press the final digit the

control unit stores the code and displays the System

Options menu.

Note: To disable this option key in “0000” over the

existing code.

To ensure that users cannot reset the system after alarm

unless they enter an anti-code:

1. Select System Options – User reset – Zone Alarms and set

it to “No” (this ensures that users cannot reset after

an alarm).

2. If DD243 is enabled then select System Options –

DD243 – Confirmed Reset and set it to Installer.

Silence Alerts

This option controls the length of time that the keypad

gives the alert tone (a brief ‘beep’ every few minutes)

when there is an alert. The options are:

User

The keypad gives the tone until a user keys in their

access code to acknowledge the alert.

30, 60, 120 minutes

The keypad gives the alert tone for the selected time.

No Alert Tones

The keypad gives no alert tone. (The red LEDs around

the navigation key glow to show that there is an

alert.)

Mains Fail Delay

This option controls the length of time that the control

unit waits until starting an alert if the mains supply fails.

1 2 ... 58 59 60 61 62 63 64 65 66 67 68 ... 115 116

Pas de commentaire

Cooper Security i-on40 Guide d'installation Page 63