Cooper Security i-on40 Guide d'installation télécharger pdf (Page 53)

i-on40 Installer Mode Programming

Page 49

This option lets you change the zone wiring type. Note

that there are several options of resistor values for FSL:

the keypad display shows the alarm contact resistor/end

of line resistor values for each option.

If you select “4 Wire CC” then the control panel provides

eight wired zones, numbered zone 01 to zone 08.

If you select any of the FSL options then the control unit

provides 16 wired zones, numbered zone 01 to zone 16.

See i-on40 Installation Guide for wiring details.

User Access

To give users access to various system facilities select

System Options – User Access. Press the u or n keys to

scroll up or down the list on the display. To allow access

press > repeatedly until “Yes” appears next to the

selected option. To deny access press > until “No”

appears next to the selected option. Press Y when you

have finished.

PA Keys Active

This option allows users to start an alarm from the

keypads by pressing both the Panic Alarm keys at the

same time. This option applies to all keypads, both radio

and wired, and is not affected by allocating keypads to

specific partitions.

Yes The PA keys on all keypads are functional.

No The PA keys are disabled.

Quick Set

Note: If you enable the quick set keys the control unit no

longer complies with EN50131.

This option controls the operation of the A, B, C or D

keys.

Yes It is possible to set the alarm system by pressing

A, B, C or D without entering an access code.

No The user must enter an access code (or present a

tag) before pressing the A, B, C or D keys.

1 2 ... 48 49 50 51 52 53 54 55 56 57 58 ... 115 116

Pas de commentaire

Cooper Security i-on40 Guide d'installation Page 53