Cooper Security i-on40 Guide d'installation télécharger pdf (Page 66)

Installer Mode Programming i-on40

Page 62

control unit ends the call and then re-attempts to

connect up to a maximum of 15 times.

Alternate.

The control unit reports to one of the two telephone

numbers in the Phone Book.

Operation: The control unit dials the first telephone

number and attempts to connect to the ARC. If it

fails, it will then close down and dial the second

telephone number and attempt to connect to the

ARC. If received and acknowledged on this attempt,

the alarm transmission is complete. If the control unit

fails to connect to the second telephone number, it

will close down again and re-attempt to connect to

the first telephone number. The control unit will

continue to shuttle between the two numbers up to

15 times.

Phone Book

This option appears only when there is an i-sd02 or i-

gsm02 module fitted. Use this menu to store two

telephone numbers that the control unit uses to report

alarms to the ARC. The control unit accepts one

telephone number if you choose Single in the Call Mode

menu, or two telephone numbers if you select Alternate

in the Call Mode menu.

The control unit can store telephone numbers up to 31

digits long.

Use the u and n keys to move the cursor backwards and

forwards through the number if you wish to edit it.

Press

< to delete the digit to left of the cursor.

Press * to add a 2 second pause, if required. The display

shows this as a comma.

IP Network

This option appears if a GPRS or Ethernet module is

fitted. Use it to program alarm receiving company

destinations that the control unit must report to over the

internet.

Note: Before programming the control unit to use the IP

Network please make sure that:

1 2 ... 61 62 63 64 65 66 67 68 69 70 71 ... 115 116

Pas de commentaire

Cooper Security i-on40 Guide d'installation Page 66