Cooper Security i-on40 Guide d'installation télécharger pdf (Page 61)

i-on40 Installer Mode Programming

Page 57

If a wirefree detector loses contact for more than two

hours then the control unit raises an alarm. The options

available for this alarm are:

Option: With system SET,

the control unit:

With system UNSET

the control unit:

Disabled Does nothing. Does nothing.

Fault Logs the event (but

does NOT display any

alert or fault tone).

Displays an Alert and

sounds a fault tone and

logs the event.

Jamming

The control unit can detect interfering (or "jamming")

radio signals. To enable jamming detection select System

Options - Jamming.

If the control unit detects jamming once you have

enabled this option then the display shows an Alert

message for the user.

Force Set

You may wish to allow a user with a remote control to set

the alarm system when one or more of the detectors are

not working or are open (active).

Note: If you enable “Force Set” then the system does not

comply with EN50131.

There are three options available:

Off

The remote control user cannot force set the system,

even if you have applied the force set zone attribute

to any zones.

Confirm

The remote control user can force set the system.

They must operate as follows: 1) the user presses the

appropriate button to set the system, 2) the control

unit does not start setting, 3) the user presses the

same remote control button to confirm that they wish

to continue setting the system.

1 2 ... 56 57 58 59 60 61 62 63 64 65 66 ... 115 116

Pas de commentaire

Cooper Security i-on40 Guide d'installation Page 61