Cooper Security i-on40 Guide d'installation télécharger pdf (Page 75)

i-on40 Installer Mode Programming

Page 71

1. Start with the control unit lid off and the tamper

switch open.

2. At the keypad select Use Lid Tamper and press Y.

3. At the control unit hold down the tamper switch.

When the red LED on the I-SD02 glows recite your

message.

4. Release the tamper switch.

5. Pulse the tamper switch briefly.

The i-sd02 plays back your recording.

6. Go back to the keypad and press X.

7. If required, replace the control unit lid. DO NOT

replace the control unit lid until you have left the

“Use Lid Tamper” mode.

Phone Book

To record the telephone numbers that you wish to use,

select Communications – Speech Dialler – Phone Book. (See

“Destinations” on page 72 for instructions how to link

messages to phone numbers.)

Select one of the telephone numbers.

The display shows the current digits of the selected

telephone number.

Key in the telephone number. Press * to add a two

second pause, if required. The display shows this as a

comma.

Press Y when you are happy that the number is correct.

The display then gives you a chance to key in a name for

that number. The control unit will display this name in the

phone book to help you remember what destination you

wanted the message to go to. (See page 7 for hints on

editing text.) Press Y when you are happy that the name

is correct.

Note that once you have set the speech dialler call mode

to “enabled” (see page 70) and assigned a report trigger

a message, and a message to a telephone number (see

below) then the control unit makes this number available

in the User Menu. User 01 can enter a new telephone

1 2 ... 70 71 72 73 74 75 76 77 78 79 80 ... 115 116

Pas de commentaire

Cooper Security i-on40 Guide d'installation Page 75