Cooper Security i-on40 Guide d'installation télécharger pdf (Page 20)

Installer Mode Programming i-on40

Page 16

2. Scroll through the list of partitions for that zone.

Press the > or < keys to change the status of the

zone. “Yes” means the zone is allocated to that

partition.

3. Press Y to save your changes and return to the list of

zones.

When delivered from the factory, or if you restore the

control unit to factory settings, then all zones belong to

partition 1.

Zone Attributes

Note: This menu does not appear if a zone has the type

“Not Used”.

You can assign more than one attribute to a zone. Some

attributes are not available for certain zone types. The

display shows the only available attributes for the zone

type you select.

To enable an attribute for a zone press > or < until the

bottom line of the display shows a “Yes”.

Chime

When enabled by the user, the system gives a non-

alarm warning tone when any zones programmed as

‘Chime’ are opened. This facility operates only while

the system is unset.

Soak Test

Use this zone attribute if you want to place under

long term test a detector that you suspect is giving

false alarms. Zones with this attribute are disabled

for 14 days after you return the control unit to

user/unset mode. If the zone remains inactive for the

whole fourteen days then after midnight on the 14th

day the control unit returns the zone to normal use.

If the zone is activated during those 14 days while

the system is set then the control unit logs the event

as a “Soak Test Fail Zn” (n is the zone number)

without sounding any sirens or starting

communications. The control unit also lights the red

LEDs around the navigation key on the keypad to

alert the user.

You can apply the soak test attribute to Normal

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 115 116

Pas de commentaire

Cooper Security i-on40 Guide d'installation Page 20