Cooper Security i-on40 Guide d'installation télécharger pdf (Page 24)

Installer Mode Programming i-on40

Page 20

might part set partitions 1 and 2, but on keypad 2 it

could be programmed to full set partition 3.

In addition, each of the A, B, C or D keys can have a

name. The keypad displays this name while the system is

setting after the user presses that key.

To name and assign the action of a quick set key:

1. Select Detectors/Devices - Wired Keypads.

The bottom line of the display shows the first in a list

of the wired keypads.

2. Press u or n followed by > to select the keypad you

wish to program.

The bottom line of the display shows “Name”.

3. Press u or n until the bottom line of the display

shows the key you wish to program, then press >.

The top line of the display shows the keypad number

and the key that you are programming. The bottom

line of the display shows “Name”.

4. Press > if you wish to give a name to the quick set

key.

The name you key-in will appear on the display when

the user presses the quick set key. (For hints on

editing names see page 7).

Press Y when you have finished keying-in the name.

5. Press u or n until the bottom line of the display

shows “Setting” and then press >.

The bottom line of the display shows “*Set”.

6. Press Y.

The bottom line of the display shows the first item in

a list of the partitions. The right hand end of the

bottom line shows the setting state that you want the

key to produce for that partition.

7. Press < or > change the setting state. The options

are: Full Set, Part Set, or None (no action).

8. Press u or n to scroll through the list of partitions.

1 2 ... 19 20 21 22 23 24 25 26 27 28 29 ... 115 116

Pas de commentaire

Cooper Security i-on40 Guide d'installation Page 24