Cooper Security i-on160EX Guide d'installation télécharger pdf (Page 12)

i-on160

Page 6

Basic Programming Procedures

Programming Before Installation

If you prefer, you can program the control unit before installing the system in

its final location. You will need to temporarily connect a keypad to the control

unit.

It is possible to operate the control unit from battery power (or a 12Vdc

supply) without connecting the unit to a mains supply. However, in order to

start the control unit processor running you must briefly short the Kick Start

pins together after connecting the battery.

When programming the system while it is running on battery only, remember

to leave the Installer Menu before removing power. If you do not do so all your

changes will be lost, see Important! Saving Changes on page 8.

If you wish to program the control unit from a laptop or PC you can do this by

connecting the control unit to your PC via Ethernet. You will need a CAT 5

patch cable and a laptop or PC with a standard web browser. See the separate

publication i-on160EX Web Server Set Up Guide for instructions on how to set

up your PC/laptop and the control unit.

Entering and Leaving the Installer Menu

When you enter the Installer Menu from a keypad, the alarm system is

effectively disabled. While the system is in Installer Menu:

Any other user trying to set the system from a keypad will see the message

“Installer on Site”.

All PAs (including radio PAs), fire alarm zones, 24 hour zones and tampers

are disabled.

Note that this does not apply if you are using the web browser interface from a

PC. If you have logged into the system from a PC then the alarm system is

active.

To Enter the Installer Menu:

1. Make sure the system is unset and showing the

standby screen (time and date).

i-on160EX

12:00 23/07/2010

2. Key in the Installer access code. When delivered

from the factory, at Security Grade 2 the

default Installer access code is “7890”. The

default user code is “1234”. At Security Grade 3

the codes are “567890” and “123456”

respectively.

As you start to key in the code the display

shows:

Enter Access Code:

(* )

When you key in the last digit of the access

code the display MAY show:

User Code Required

( )

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 179 180

Commentaires sur ces manuels

Pas de commentaire

Cooper Security i-on160EX Guide d'installation Page 12

Commentaires sur ces manuels

Produits connexes et manuels pour Systèmes de contrôle d'accès de sécurité Cooper Security i-on160EX