Cooper Security i-on160EX Guide d'installation télécharger pdf (Page 16)

Basic Programming Procedures i-on160

Page 10

11. Press u or n to display the desired wirin

type

on the bottom line of the display.

WIRED ZONE TYPE

4-wire CC

12. Press Y to confirm the selection.

The system loads all defaults except for the

Log.

Note: The log is protected and cannot be erased by

the Installer or any user.

The display briefly shows:

Factory defaults

restored

Followed by:

RESTORE DEFAULTS

Factory defaults >

13. Press X until the display shows:

Leave

Installer mode?

14. Press Y.

The display shows:

Please wait...

The control unit scans the bus. After a delay of

anywhere between a few seconds to a few tens

of seconds (depending on the number of

expanders fitted) the display shows, for

example:

FOUND 3, LOST 0

Found R1-01

The top line of the display shows the number of

new devices found. Because you have restored

factory defaults the control unit has erased its

internal list of bus devices and the display

should not show any missing devices. So, if a

device is attached to the bus but not powered

up then the control unit will not detect it. The

bottom line of the display shows the first in the

list of found devices. Press n to see any other

items in the list.

15. Press Y.

The display shows:

Accept all changes

to bus?

16. Press Y.

The control unit saves your changes and the

display shows the time and date:

i-on160EX

12:00 02/11/2010

Note: If the control unit has an i-sd02 fitted then the keypad will show an alert

when you leave Installer Mode. The alert is for PSTN Line Fault. The

reason for the alert is that defaulting the system has deleted all

programmed telephone numbers. Re-enter Installer Menu and either re-

key the appropriate telephone numbers, or disable communications by

setting Communications – ARC Reporting – Call Mode to “Disabled”.

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 179 180

Commentaires sur ces manuels

Pas de commentaire

Cooper Security i-on160EX Guide d'installation Page 16

Commentaires sur ces manuels

Produits connexes et manuels pour Systèmes de contrôle d'accès de sécurité Cooper Security i-on160EX